Power supply to the temperature sensor built into the rear seat cushion heater stops if one of the following occurs: 1) an open or short occurs in the temperature sensor circuit; or 2) the temperature sensor is damaged and its output value does not change.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B14C2 | Rear Right Seat Heat Sensor Circuit | Seat heater temperature sensor malfunction | ·
Air conditioning amplifier assembly ·
Rear seat cushion heater RH (seat heater assembly) ·
Wire harness or connector |
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
DTC B14C2 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click hereVehicle Interior>SEAT>REAR SEAT CUSHION HEATER (for 60/40 Split Seat Type RH Side)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>SEAT>REAR SEAT CUSHION HEATER (for 60/40 Split Seat Type RH Side)>REMOVAL
Disconnect the H65 air conditioning amplifier assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H65-5 (TFAR) - f1-6 | Always | Below 1 Ω |
| H65-5 (TFAR) or f1-6 - Body ground | Always | 10 kΩ or higher |
| H65-1 (SG-6) - f1-7 | Always | Below 1 Ω |
| H65-1 (SG-6) or f1-7 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG