Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Parking Support Brake System (Forward/reverse Type))
RM37A0E _56 Audio / Visual / Telematics _086880 PARK ASSIST / MONITORING _0420182 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/ Parking Support Brake System (Forward/reverse Type)) D

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/ Parking Support Brake System (Forward/reverse Type))  CALIBRATION  


NOTICE:

When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the TOYOTA parking assist-sensor system may not operate correctly.


ADJUST TOYOTA PARKING ASSIST-SENSOR SYSTEM


a.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during TOYOTA parking assist-sensor system removal/installation are shown below.

Part Name Operation Adjustment Item Proceed to
Clearance warning ECU assembly Replacement Steering angle neutral point* (Click here)
Bumper type registration
Ultrasonic sensor detection angle registration
Ultrasonic sensor
·

Removal and installation

·

Replacement


Measurement of Ultrasonic sensor detection angle
Ultrasonic sensor detection angle registration
An ultrasonic sensor becomes misaligned Measurement of Ultrasonic sensor detection angle
Ultrasonic sensor detection angle registration
An ultrasonic sensor is subjected to impact Measurement of Ultrasonic sensor detection angle
Ultrasonic sensor detection angle registration
Blind spot monitor sensor Replacement Blind spot monitor beam axis confirmation (Click here)

*: The steering sensor zero point can also be calibrated by driving the vehicle.

Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>INITIALIZATION