Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Parking Support Brake System)
RM37A0E _56 Audio / Visual / Telematics _086880 PARK ASSIST / MONITORING _0420183 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Parking Support Brake System) D

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Parking Support Brake System)  CALIBRATION  


NOTICE:

When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the TOYOTA parking assist-sensor system may not operate correctly.


ADJUST TOYOTA PARKING ASSIST-SENSOR SYSTEM


The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during TOYOTA parking assist-sensor system removal/installation are shown below.

Part Name Operation Adjustment Item Proceed to
Clearance warning ECU assembly Replacement Registration of bumper type Procedure 1
Ultrasonic sensor (front left sensor, front left center sensor, front right center sensor, front right sensor) Initialization of ultrasonic sensors (front left sensor, front left center sensor, front right center sensor, front right sensor) Procedure 2
Ultrasonic sensor (rear left sensor, rear left center sensor, rear right center sensor, rear right sensor) Initialization of ultrasonic sensors (rear left sensor, rear left center sensor, rear right center sensor, rear right sensor)
Blind spot monitor sensor Replacement Blind spot monitor beam axis confirmation (Click here)


REGISTRATION OF BUMPER TYPE (PROCEDURE 1)



b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / Clearance Warning / Utility.

Body Electrical > Clearance Warning > Utility
Tester Display
ECU Calibration
50005 438 2535

f.

Select "Clearance Sonar ECU" and perform steering adjustment according to the display on the GTS.


g.

Enter the bumper type using the GTS.

Bumper Type Value
Standard 1


h.

Disconnect the GTS from the DLC3.



REGISTRATION OF ULTRASONIC SENSORS (PROCEDURE 2)



b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / Clearance Warning / Utility.

Body Electrical > Clearance Warning > Utility
Tester Display
ECU Calibration
50005 438 2535

f.

Select "Fr Sensor or Bumper" or "Rr Sensor or Bumper" and perform automatic adjustment according to the display on the GTS.


g.

Disconnect the GTS from the DLC3.