Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM37A0E _56 Audio / Visual / Telematics _086877 AUDIO / VIDEO _0420540 AUDIO AND VISUAL SYSTEM Y

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the audio and visual system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
·

When troubleshooting, check that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.

·

Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

·

The following 5 items are important points for problem analysis:

What Vehicle model, system name
When Date, time, occurrence frequency
Where Road conditions
Under what conditions? Driving conditions, weather conditions
How did it happen? Problem symptoms


Result:
Proceed to
NEXT



NEXT

3.INSPECT AUXILIARY BATTERY
3.INSPECT AUXILIARY BATTERY
a.

for HV Model

i.

Measure the auxiliary battery voltage with the ignition switch off.

Standard Voltage:

11 to 14 V


HINT:

If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.




b.

for Gasoline Model

i.

Measure the auxiliary battery voltage.

Standard Voltage:

11 to 14 V


HINT:

If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.




Result:
Proceed to
NEXT



NEXT

4.CHECK CABIN
4.CHECK CABIN
a.

Check that condensation is not likely to occur in the cabin and that the temperature is not high or extremely low in the cabin.

OK:

Condensation is not likely being produced and the temperature is not high or extremely low.


HINT:
·

A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.

·

The audio and visual system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.




Result:
Proceed to
OK
NG



OK

5.CHECK CAN COMMUNICATION SYSTEM*

NG

SET CABIN TO APPROPRIATE TEMPERATURE

5.CHECK CAN COMMUNICATION SYSTEM*

Result:
Result Proceed to
CAN DTCs are not output. A
CAN DTCs are output. B



A

6.CHECK FOR DTC*

B

6.CHECK FOR DTC*
a.

Check for DTCs.

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Result Proceed to
DTCs are output. A
DTCs are not output. B



A

7.DTC CLEAR*

B

10.PROBLEM SYMPTOMS TABLE
7.DTC CLEAR*
a.

Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs
50002 212
HINT:

The present DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.



Result:
Proceed to
NEXT



NEXT

8.RECHECK FOR DTC*
8.RECHECK FOR DTC*
a.

Recheck for DTCs.

Body Electrical > Navigation System > Trouble Codes
50001 212
HINT:
·

Even if the problem symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.

·

If more information is needed, perform a recheck using the "System Check Mode" screen after rechecking for DTCs using the GTS.

·

Check for DTCs and inspect the area that the code indicates.




Result:
Result Proceed to
DTCs are output. A
DTCs are not output. B



A

9.DIAGNOSTIC TROUBLE CODE CHART

B

10.PROBLEM SYMPTOMS TABLE
9.DIAGNOSTIC TROUBLE CODE CHART
a.

Find the output DTC in Diagnostic Trouble Code Chart.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART


Result:
Proceed to
NEXT



NEXT

12.CHECK CIRCUIT
10.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>PROBLEM SYMPTOMS TABLE

HINT:

If the symptoms do not recur and no DTCs are output, attempt to reproduce the symptoms.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING



Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table. A
Fault is listed in Problem Symptoms Table. B



A

11.PERFORM TROUBLESHOOTING BASED ON PROBLEM SYMPTOM

B

12.CHECK CIRCUIT
11.PERFORM TROUBLESHOOTING BASED ON PROBLEM SYMPTOM

Result:
Proceed to
NEXT



NEXT

12.CHECK CIRCUIT
12.CHECK CIRCUIT
a.

Adjust, repair or replace as necessary.


Result:
Proceed to
NEXT



NEXT

13.RECHECK FOR DTC*
13.RECHECK FOR DTC*
a.

After clearing DTCs, recheck for DTCs.

Body Electrical > Navigation System > Clear DTCs
50002 212
Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Proceed to
NEXT



NEXT

14.PERFORM CONFIRMATION TEST
14.PERFORM CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END