Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM37A0E _56 Audio / Visual / Telematics _086877 AUDIO / VIDEO _0420540 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Steering Pad Switch Circuit  


DESCRIPTION

This circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly.

If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly.

If there is a short in the circuit, the same condition as when a switch is continuously depressed occurs.

Therefore, the radio and display receiver assembly cannot be operated using the steering pad switch assembly, and the radio and display receiver assembly itself will not function.

WIRING DIAGRAM

E437684E01
1.052,4.813 5.333,5.01 4.281,0.198 10 false Steering Pad Switch Assembly 4.052,3.417 5.865,3.74 1.813,0.323 10 false Spiral Cable Sub-assembly 5.948,3.427 7.135,3.896 1.188,0.469 10 false Radio and Display Receiver Assembly 5.948,3.271 6.406,3.469 0.458,0.198 10 false H1 2.573,2.365 3.344,2.771 0.771,0.406 10 false MODE 1.448,3.792 2.573,4.042 1.125,0.25 10 false On/off hook 2.604,3.802 3.063,4 0.458,0.198 10 false Voice 0.406,1.26 1.479,1.458 1.073,0.198 10 false Volume- 1.177,1.271 2.25,1.469 1.073,0.198 10 false Volume+ 1.99,1.281 3.063,1.479 1.073,0.198 10 false Seek- 2.604,1.271 3.677,1.469 1.073,0.198 10 false Seek+ 4.813,2.823 5.281,3.031 0.469,0.208 10 false AU2 4.813,1.719 5.281,1.927 0.469,0.208 10 false EAU 4.823,0.604 5.292,0.813 0.469,0.208 10 false AU1 4.063,3.26 4.521,3.458 0.458,0.198 10 false H24 5.302,0.604 5.615,0.802 0.313,0.198 10 false 12 5.323,2.823 5.635,3.021 0.313,0.198 10 false 5 5.323,1.719 5.635,1.917 0.313,0.198 10 false 4 6.104,2.833 6.417,3.031 0.313,0.198 10 false 22 6.104,1.719 6.417,1.917 0.313,0.198 10 false 24 6.104,0.615 6.417,0.813 0.313,0.198 10 false 21 6.333,0.698 6.802,0.906 0.469,0.208 10 false SW1 6.333,1.833 6.802,2.042 0.469,0.208 10 false SWG 6.323,2.917 6.792,3.125 0.469,0.208 10 false SW2

CAUTION / NOTICE / HINT

NOTICE:

The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (STEERING PAD SWITCH SIGNAL)
a.

Disconnect the H1 radio and display receiver assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H1-21 (SW1) - H1-24 (SWG) No switch pushed 95 to 105 kΩ
Seek+ switch pushed Below 2.5 Ω
Seek- switch pushed 313 to 345 Ω
Volume+ switch pushed 950 to 1050 Ω
Volume- switch pushed 2955 to 3265 Ω
H1-22 (SW2) - H1-24 (SWG) No switch pushed 95 to 105 kΩ
MODE switch pushed Below 2.5 Ω
On/off hook switch pushed 950 to 1050 Ω
Voice switch pushed 2955 to 3265 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT STEERING PAD SWITCH ASSEMBLY
2.INSPECT STEERING PAD SWITCH ASSEMBLY
a.

Remove the steering pad switch assembly.

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>REMOVAL


b.

Inspect the steering pad switch assembly.

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

3.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

3.INSPECT SPIRAL CABLE SUB-ASSEMBLY
a.

Remove the spiral cable sub-assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL


b.

Inspect the spiral cable sub-assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION


Result:
Proceed to
OK
NG



OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY)

NG

REPLACE SPIRAL CABLE SUB-ASSEMBLY