The cooler compressor assembly receives refrigerant compression demand signals from the air conditioning amplifier assembly.
Based on this signal, the cooler compressor assembly changes the amount of compressor output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory |
|---|---|---|---|---|
| B1451 | Compressor Solenoid Circuit | Open or short in compressor solenoid circuit | ·
Cooler compressor assembly ·
Harness or connector ·
Air conditioning amplifier assembly |
- |
| *a | Front view of wire harness connector
(to Cooler Compressor Assembly) |
Disconnect the C59 cooler compressor assembly connector.
Using an oscilloscope, check the waveform.
| Item | Content |
|---|---|
| Tester Connection | C59-2 (SOL+) - Body ground |
| Tool Setting | 5 V/DIV., 500 μs./DIV. |
| Condition | ·
Engine running ·
Blower switch: LO ·
A/C switch: On |
Waveform is similar to that shown in the illustration.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the C59 cooler compressor assembly connector.
Disconnect the H62 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C59-2 (SOL+) - H62-18 (SOL+) | Always | Below 1 Ω |
| C59-2 (SOL+) or H62-18 (SOL+) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG