Home › Drivetrain › P810 (HYBRID TRANSMISSION / TRANSAXLE) › OIL PUMP
RM37A0E _52 Drivetrain _086860 P810 HYBRID TRANSMISSION / TRANSAXLE _0420890 OIL PUMP A

P810 HYBRID TRANSMISSION / TRANSAXLE  OIL PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during oil pump removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly

·

Replacement of EGR valve assembly

·

Gas leak from exhaust system is repaired


Perform Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 53852B 1.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

Hide 53851D 2.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

Hide 51420 4.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY

Hide 32930G 6.DISCONNECT NO. 2 TRANSMISSION OIL COOLER HOSE ASSEMBLY

a.
C426786

Slide the 2 clips and disconnect the No. 2 transmission oil cooler hose assembly from the oil pump with motor assembly.


Hide 35300B 7.REMOVE OIL PUMP WITH MOTOR ASSEMBLY

a.
C426785

Remove the bolt and wire harness clamp bracket from the oil pump with motor assembly.


b.
C426788

Disconnect the oil pump with motor assembly connector.


c.
C426789

Remove the 2 bolts and oil pump with motor assembly from the engine assembly.