Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for HV Model LHD)
RM37A0E _54 Brake _086869 BRAKE SYSTEM (OTHER) _0420921 BRAKE PEDAL(for HV Model LHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for HV Model LHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during brake pedal support assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: Learning can also be performed using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
Removal/installation of brake pedal support assembly Perform "Calibration"
·

DTCs are stored

·

ABS warning light illuminates

·

Brake system warning light (yellow indicator) illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)

NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.

·

While the auxiliary battery is connected, even if the ignition switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.



PROCEDURE

Hide 1.REMOVE BRAKE MASTER CYLINDER WITH PUMP ASSEMBLY

Hide 89510D 2.REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY

Hide 3.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
C426254

Disengage the 2 clamps to separate the wire harness from the brake pedal support assembly.


b.
C426255

Remove the bolt and separate the brake pedal support assembly while avoiding the stud bolts of the brake master cylinder support base.

NOTICE:

Be careful not to deform the bracket of the instrument panel reinforcement assembly.



Hide 84345 4.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

a.
C426257

Disengage the 2 claws and remove the stop light switch mounting adjuster.


Hide 47121 5.REMOVE BRAKE PEDAL PAD

a.

Remove the brake pedal pad from the brake pedal support assembly.