Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for Gasoline Model LHD)
RM37A0E _54 Brake _086869 BRAKE SYSTEM (OTHER) _0420922 BRAKE PEDAL(for Gasoline Model LHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for Gasoline Model LHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during brake pedal support assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: Learning can also be performed using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 1.REMOVE BATTERY

Hide 3.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


Hide 4.DISCONNECT BRAKE LINE

a.
C425712

Using a union nut wrench, disconnect the 2 brake lines.

NOTICE:
·

Do not damage or deform the brake lines.

·

Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.




Hide 73900 5.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 84340 6.REMOVE STOP LIGHT SWITCH ASSEMBLY

Hide 47264A 7.REMOVE PUSH ROD PIN

a.
C425720

Remove the clip and push rod pin.


Hide 8.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
C425721

Disconnect the connector.


b.

Disengage the 2 clamps to separate the wire harness from the brake pedal support assembly.


c.
C425722

Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.


d.
C425723

Remove the 4 nuts and push the brake booster with master cylinder toward the engine compartment.

NOTICE:
·

Do not apply excessive force to the brake lines.

·

Do not apply excessive force to the wire harness.




e.

Remove the brake pedal support assembly while avoiding the stud bolts of the brake booster with master cylinder and brake booster support base.

NOTICE:

Be careful not to deform the bracket of the instrument panel reinforcement assembly.



Hide 47101A 9.REMOVE BRAKE PEDAL RETURN SPRING

a.
C425724

Remove the brake pedal return spring from the brake pedal support assembly.


Hide 84345 10.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

a.
C425725

Disengage the 2 claws and remove the stop light switch mounting adjuster.


Hide 47121 11.REMOVE BRAKE PEDAL PAD

a.

Remove the brake pedal pad from the brake pedal support assembly.