Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER PUMP
RM37A0E _54 Brake _086869 BRAKE SYSTEM (OTHER) _0420926 BRAKE BOOSTER PUMP(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER PUMP(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during brake booster with accumulator pump assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: Learning can also be performed using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
Replacement of brake booster with accumulator pump assembly
1.

Bleed air

2.

Perform "Calibration"


·

DTCs are stored

·

ABS warning light illuminates

·

Brake system warning light (yellow indicator) illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)

NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.

·

While the auxiliary battery is connected, even if the ignition switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.



PROCEDURE

Hide 1.REMOVE BRAKE MASTER CYLINDER WITH PUMP ASSEMBLY

Hide 44551C 2.REMOVE NO. 1 BRAKE ACTUATOR TUBE

Hide 47070B 3.REMOVE BRAKE BOOSTER WITH ACCUMULATOR PUMP ASSEMBLY

a.
C427630

Slide the clip and disconnect the No. 2 reservoir hose from the brake booster with accumulator pump assembly.


b.
C427631

Disengage the 3 clamps to separate the wire harness.


c.

Remove the nut, brake booster with accumulator pump assembly, brake booster pump bushing and brake actuator case collar.