Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM WARNING SWITCH
RM37A0E _54 Brake _086869 BRAKE SYSTEM (OTHER) _0420928 VACUUM WARNING SWITCH G

BRAKE SYSTEM (OTHER)  VACUUM WARNING SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 83390H 3.INSPECT VACUUM WARNING SWITCH ASSEMBLY

a.

Start the engine and stop it after 1 or 2 minutes.


b.

Remove the battery.

Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>REMOVAL


c.

Disconnect the connector from the vacuum warning switch assembly.


d.

Measure the resistance of the vacuum warning switch assembly.

Standard Resistance:

10 kΩ or higher



e.

With the engine stopped, depress the brake pedal several times to release vacuum from the brake booster assembly, and measure the resistance of the vacuum warning switch assembly.

Standard Resistance:

Below 1 Ω



f.

Connect the connector to the vacuum warning switch assembly.


g.

Install the battery.

Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>INSTALLATION