This procedure is for troubleshooting when the brake warning light (yellow) remains on but no DTCs are output.
The No. 2 skid control ECU (brake actuator assembly) controls the brake warning light (yellow) in the combination meter assembly via CAN communication.
To ensure that the electric parking brake does not operate, wait for 3 minutes or more with the ignition switch off, the driver door closed, and the brake pedal not depressed, then disconnect each connector, fuse and relay.
After replacing the No. 2 skid control ECU (brake actuator assembly), perform calibration (linear solenoid valve offset learning, SM solenoid valve offset learning, brake pedal stroke sensor assembly zero point calibration, system information memorization, and yaw rate and acceleration sensor zero point calibration) after performing "Reset Memory".
When replacing the No. 2 skid control ECU (brake actuator assembly), operate the electric parking brake switch (electric parking brake switch assembly) as the parking brake indicator light (red) blinks when the ignition switch is first turned ON.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Chassis / Brake/EPB / Utility / Vehicle Control History (RoB).
d. Using the GTS, check for Vehicle Control History.
| Tester Display |
|---|
| Vehicle Control History (RoB) |
If vehicle control history is stored when the electric parking brake system is suspended, the brake warning light (yellow) illuminates.
| Result | Proceed to |
|---|---|
| There is no vehicle control history for when the electric parking brake system was suspended. | A |
| There is vehicle control history for when the electric parking brake system was suspended. | B |
A
B
After performing troubleshooting and repair regarding vehicle control history, clear the vehicle control history.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform the Active Test of the combination meter assembly using the GTS.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display |
|---|
| ECB Warning |
Check the combination meter assembly.
The brake warning light (yellow) turns on or off in accordance with GTS operation.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING