Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM (for Gasoline Model) › 2020.02–2020.11
RM37A0E _54 Brake _086873 PARKING BRAKE _0420959 ELECTRIC PARKING BRAKE SYSTEM(for Gasoline Model) C

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM(for Gasoline Model)  C123A14  Supply Voltage Circuit IG Open  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note
C123A14 Supply Voltage Circuit IG Open
·

Diagnosis Condition:

Ignition switch ON

·

Malfunction Status:

When the ECM is communicating via CAN communication, IG power is not input to the skid control ECU (brake actuator sub-assembly).

·

Detection Time:

Approximately 15 seconds


·

Wire harness and connector

·

Skid control ECU (brake actuator assembly)


DTC stored An electric parking brake system malfunction is displayed on the multi-information display.

WIRING DIAGRAM

C432830E01
1.688,1.583 2.917,1.781 1.229,0.198 10 false ECU-IG1 NO. 2 4.188,1.427 4.625,1.667 0.438,0.24 10 false IG1 3.885,1.313 4.323,1.552 0.438,0.24 10 false 45 4.167,2.167 4.667,2.417 0.5,0.25 10 false A39 4.167,2.333 5.75,2.917 1.583,0.583 10 false Skid Control ECU (Brake Actuator Assembly)

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following procedure.

·

The electric parking brake may still operate up to 20 seconds after the ignition switch is turned off. Before disconnecting connectors or fuses, turn the ignition switch off and wait 20 seconds or more.

·

After replacing the skid control ECU (brake actuator assembly), perform yaw rate and acceleration sensor zero point calibration and store system information memorization.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>UTILITY

·

When replacing the skid control ECU (brake actuator assembly), operate the electric parking brake switch (electric parking brake switch assembly) as the parking brake indicator light (red) blinks when the ignition switch is first turned ON.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (IG1 TERMINAL VOLTAGE)
a.

Disconnect the A39 skid control ECU (brake actuator assembly) connector.


b.

Turn the ignition switch to ON.


c.
C342413C26
1.458,0.125 1.875,0.375 0.417,0.25 2.5,1.823 2.365,1.354 true 1.552,0.167 2.01,0.365 0.458,0.198 10 false A39 2.438,1.844 2.896,2.042 0.458,0.198 10 false IG1 0.104,0.104 0.563,0.302 0.458,0.198 10 false *a
*a Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly))


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A39-45 (IG1) - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR