MALFUNCTION DESCRIPTION
The main CPU and sub CPU of the Hybrid vehicle control ECU monitor each other.
The cause of this malfunction may be the following:
Hybrid vehicle control ECU malfunction
The hybrid vehicle control ECU monitors its internal operation and will store these DTCs when it detects an internal malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate |
|---|---|---|---|---|---|
| P060694 | Hybrid/EV Powertrain Control Module Processor Unexpected Operation | The main CPU value received by the sub CPU of the hybrid vehicle control ECU exceeds the threshold for a certain period of time.
(1 trip detection logic) |
Hybrid vehicle control ECU | Comes on | Master Warning:
Comes on |
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 2WD)>UTILITY
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off and wait for 2 minutes or more.
Turn the ignition switch to ON and turn the GTS on.
Turn the ignition switch to ON (READY) and wait for 10 seconds or more.
Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE, perform driving pattern again.
Check for DTCs.
| Result | Proceed to |
|---|---|
| P060694 only is output. | A |
| DTCs except P060694 are output. | B |
Turn the ignition switch off.
A
B