Refer to the description for DTC P0ABF11.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 4WD/AWD)>P0ABF11
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate |
|---|---|---|---|---|---|
| P1C9F1C | Hybrid/EV Battery Current Sensor for Driving Control Voltage Out of Range | The difference between IBA and IB0 exceeds the threshold.
(1 trip detection logic) |
Battery voltage sensor | Comes on | Master Warning:
Comes on |
IB0 is used for battery control and IBA is used for driving control. Although IB0 and IBA receive voltage output by the battery current sensor through the same terminal, their output may differ as they are connected through separate filter circuits within the battery voltage sensor.
| DTC No. | Data List |
|---|---|
| P1C9F1C | ·
Hybrid Battery Current for Hybrid Battery Control ·
Hybrid Battery Current for Driving Control |
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 4WD/AWD)>UTILITY
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off and wait for 2 minutes or more.
Turn the ignition switch to ON and turn the GTS on.
With ignition switch ON and wait for 10 seconds or more.
Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE, perform driving pattern again.
Check and record any HV system DTCs and Freeze Frame Data.
| Result | Proceed to |
|---|---|
| "Only DTC P1C9F1C is output" or "DTC P1C9F1C and DTCs other than those in the following table are output". | A |
| DTC P1C9F1C and any of the DTCs in the following table are output at the same time. | B |
| Relevant DTC | |
|---|---|
| P0AFC00 | Hybrid/EV Battery Sensor Module |
| P0AFC96 | Hybrid/EV Battery Sensor Module Component Internal Failure |
| P308A12 | Hybrid/EV Battery Voltage Sensor All Circuit Short to Auxiliary Battery |
| P1CBB12 | Hybrid/EV Battery Current Sensor Power Supply Circuit Short to Auxiliary Battery |
| P1CBB14 | Hybrid/EV Battery Current Sensor Power Supply Circuit Short to Ground or Open |
| P0ABF15 | Hybrid/EV Battery Current Sensor "A" Circuit Short to Auxiliary Battery or Open |
| P0ABF28 | Hybrid/EV Battery Current Sensor "A" Signal Bias Level Out of Range / Zero Adjustment Failure |
| P0ABF2A | Hybrid/EV Battery Current Sensor "A" Signal Stuck In Range |
Turn the ignition switch off.
A
B