Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › MOTOR GENERATOR CONTROL SYSTEM (for 2WD)
RM37A0E _51 Engine / Hybrid System _086850 HYBRID / BATTERY CONTROL _0420995 MOTOR GENERATOR CONTROL SYSTEM(for 2WD) C

HYBRID / BATTERY CONTROL  MOTOR GENERATOR CONTROL SYSTEM(for 2WD)  P0C3811  DC/DC Converter Temperature Sensor "A" Circuit Short to Ground  P0C3815  DC/DC Converter Temperature Sensor "A" Circuit Short to Battery or Open  P0C3D11  DC/DC Converter Temperature Sensor "B" Circuit Short to Ground  P0C3D15  DC/DC Converter Temperature Sensor "B" Circuit Short to Battery or Open  


DESCRIPTION

The motor generator control ECU (MG ECU) located in the inverter with converter assembly detects the temperature of the boost converter using the temperature sensor built into the boost converter. The motor generator control ECU (MG ECU) detects malfunctions in the boost converter temperature sensor and its wiring.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P0C3811 DC/DC Converter Temperature Sensor "A" Circuit Short to Ground Short to ground detected in boost converter temperature sensor (upper) signal circuit
(1 trip detection logic)
Inverter with converter assembly Comes on Master Warning:
Comes on
P0C3815 DC/DC Converter Temperature Sensor "A" Circuit Short to Battery or Open Open or short to +B detected in boost converter temperature sensor (upper) signal circuit
(1 trip detection logic)
Inverter with converter assembly Comes on Master Warning:
Comes on
P0C3D11 DC/DC Converter Temperature Sensor "B" Circuit Short to Ground Short to ground detected in boost converter temperature sensor (lower) signal circuit
(1 trip detection logic)
Inverter with converter assembly Comes on Master Warning:
Comes on
P0C3D15 DC/DC Converter Temperature Sensor "B" Circuit Short to Battery or Open Open or short to +B detected in boost converter temperature sensor (lower) signal circuit
(1 trip detection logic)
Inverter with converter assembly Comes on Master Warning:
Comes on

Related Data List
DTC No. Data List
P0C3811 Boosting Converter Temperature (Upper)
P0C3815
P0C3D11 Boosting Converter Temperature 1 (Lower)
P0C3D15

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>MOTOR GENERATOR CONTROL SYSTEM (for 2WD)>UTILITY


1.

Connect the GTS to the DLC3.

2.

Turn the ignition switch to ON and turn the GTS on.

3.

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

4.

Turn the ignition switch off and wait for 2 minutes or more.

5.

Turn the ignition switch to ON and turn the GTS on.

6.

With ignition switch ON and wait for 5 seconds or more.

7.

Enter the following menus: Powertrain / Motor Generator / Utility / All Readiness.

8.

Check the DTC judgment result.

HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE, perform driving pattern again.




PROCEDURE

1.REPLACE INVERTER WITH CONVERTER ASSEMBLY

NEXT

COMPLETED