MALFUNCTION DESCRIPTION
The motor generator control ECU (MG ECU), which is built into the inverter with converter assembly, and the airbag sensor assembly detect that a collision has occurred and the motor generator control ECU (MG ECU) built into the inverter with converter assembly outputs a DTC. A collision information signal is also sent to the hybrid vehicle control ECU, which then shuts off the main relay.
The cause of this DTC may be one of the following:
Collision is detected
Detection sensor system malfunction
Airbag system malfunction
Inverter with converter assembly malfunction
Communication malfunction between airbag sensor assembly and inverter with converter assembly
When a collision occurs, the motor generator control ECU (MG ECU) built into the inverter with converter assembly receives a collision signal from the airbag sensor assembly and outputs a DTC. A collision signal is also sent to the hybrid vehicle control ECU. After detecting a collision, the hybrid vehicle control ECU shuts off the high voltage system for safety.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate |
|---|---|---|---|---|---|
| P160600 | Collision detected or Collision Sensor Connection (Open) | Collision detection
A block signal is received from the airbag sensor assembly. (1 trip detection logic) |
·
Airbag sensor assembly ·
Inverter with converter assembly ·
Airbag system |
Does not come on | Master Warning:
Comes on |
| P160604 | Collision detected or Collision Sensor Connection (Open) System Internal Failure | Collision detection
Multiple wiring malfunctions occur simultaneously. (1 trip detection logic) |
·
Inverter with converter assembly ·
Airbag system |
Does not come on | Master Warning:
Comes on |
If P160600 or P160604 is output, the hybrid system cannot be started unless the DTCs are cleared using the GTS.
| DTC No. | Data List |
|---|---|
| P160600 | Airbag Status (Collision) (CAN) (Hybrid control system) |
| P160604 |
After repair has been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>MOTOR GENERATOR CONTROL SYSTEM (for 2WD)>UTILITY
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off and wait for 2 minutes or more.
Turn the ignition switch to ON and turn the GTS on.
With ignition switch ON and wait for 5 seconds or more.
Enter the following menus: Powertrain / Motor Generator / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE, perform driving pattern again.
Check the vehicle condition.
| Result | Proceed to |
|---|---|
| The vehicle is not damaged. | A |
| The vehicle is damaged. | B |
A
B
Check for DTCs.
| Result | Proceed to |
|---|---|
| P160600 or P160604 only is output, or DTCs except the ones in the table below are also output. | A |
| DTC including pending DTC of hybrid control system in the tables below is output. | B |
| DTC including pending DTC of motor generator control system in the tables below is output. | C |
| Malfunction Content | System | Relevant DTC | |
|---|---|---|---|
| Microcomputer malfunction | Hybrid control system | P060647 | Hybrid/EV Powertrain Control Module Processor Watchdog / Safety MCU Failure |
| Motor generator control system | P0A1B1F | Generator Control Module Circuit Intermittent | |
P160600 or P160604 may be output as a result of the malfunction indicated by the DTCs above.
Turn the ignition switch off.
A
B
C
Check for DTCs.
| Result | Proceed to |
|---|---|
| P160600 is output. | A |
| P160604 is output. | B |
Turn the ignition switch off.
A
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B
Check for DTCs.
| Malfunction Content | Relevant DTC | |
|---|---|---|
| Communication System Malfunction | P322F15 | Lost Communication between Drive Motor "A" and HV ECU Missing Message |
P160604 may be output as a result of the malfunction indicated by the DTCs above.
If only DTC P160604 is output, perform the diagnostic procedure of DTC P322F15 to inspect if there is an open or short to +B in the communication circuit.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>MOTOR GENERATOR CONTROL SYSTEM (for 2WD)>P322F15