Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0421002 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  C145151  High Pressure Tube Air Bleeding Not Programmed  


DESCRIPTION

If air bleeding has not been performed, the No. 1 skid control ECU (brake booster with master cylinder assembly) stores DTC C145151 to prevent the entry of air due to pump motor operation.

DTC C145151 is stored when Motor Deactivate is selected, the system will not return to normal until the air bleeding procedure is performed.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C145151 High Pressure Tube Air Bleeding Not Programmed Either of the following is detected:
·

Using the GTS, "Motor Deactivate" of the "ECB Utility" has been performed.

·

The brake booster with master cylinder assembly has been replaced.


Air bleeding not performed Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly)
HINT:
·

The DTC is cleared when the conditions return to normal.

·

ECB: Electronically Controlled Brake System




PROCEDURE

1.PERFORM AIR BLEEDING
a.

Bleed the air from the brake system.

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (for HV Model)>BLEEDING

HINT:

If air bleeding has been performed, this DTC will be cleared.



Result:
Proceed to
NEXT



NEXT

2.RECONFIRM DTC
2.RECONFIRM DTC
a.

Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.


b.

Check if the same DTC is output.

Chassis > Brake Booster > Trouble Codes
50001 466

Result:
Result Proceed to
DTC C145151 is not output. A
DTC C145151 is output. B



A

END

B