Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model) › 2020.02–2020.11
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0421002 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  C05732A  Brake Pressure Sensor "C" Signal Stuck In Range  


DESCRIPTION

The accumulator pressure sensor is built into the brake booster with master cylinder assembly and detects the accumulator pressure.

If the No. 1 skid control ECU (brake booster with master cylinder assembly) detects that the accumulator pressure sensor value is below the threshold, operation of the motor relay is requested and the pump motor built into the brake booster with accumulator pump assembly operates.

HINT:

Brake pressure sensor "C": Accumulator pressure sensor


DTC No. Detection Item DTC Detection Condition Trouble Area Note
C05732A Brake Pressure Sensor "C" Signal Stuck In Range When the pump motor is operating, the accumulator pressure sensor signal does not change for 14 seconds or more. No. 1 skid control ECU (brake booster with master cylinder assembly) Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing the No. 1 skid control ECU (brake booster with master cylinder assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>UTILITY


PROCEDURE

1.CHECK DTC
a.

Turn the ignition switch to ON.


b.

Depress the brake pedal 10 times or more to operate the pump motor.


c.

After the pump motor stops, check for DTCs.

Chassis > Brake Booster > Trouble Codes
50001 466

Result:
Result Proceed to
DTC C05732A is not output. A
DTC C05732A is output. B



A

B

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY