Refer to DTC C050C12.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C050C3A | Left Rear Wheel Speed Sensor Signal Has Too Many Pulses | When not in Dealer Mode (Signal Check) or Inspection Mode, the output of the speed sensor detected by the No. 2 skid control ECU (brake actuator assembly) is too high for 5 seconds or more. | No. 2 skid control ECU (brake actuator assembly) | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| C05123A | Right Rear Wheel Speed Sensor Signal Has Too Many Pulses | When not in Dealer Mode (Signal Check) or Inspection Mode, the output of the speed sensor detected by the No. 2 skid control ECU (brake actuator assembly) is too high for 5 seconds or more. | No. 2 skid control ECU (brake actuator assembly) | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for HV Model LHD)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT