Refer to DTC C059400.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C141C49 | Brake Booster Motor "A" Control Internal Electronic Failure | Either of the following is detected:
·
When the voltage at terminal +BI1 is between 7.3 and 16.6 V, overcurrent is detected in the motor relay for 0.054 seconds or more. ·
Overcurrent is detected in the motor fail-safe relay for 0.054 seconds or more. |
No. 1 skid control ECU (brake booster with master cylinder assembly) | Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) |
After replacing the No. 1 skid control ECU (brake booster with master cylinder assembly), perform "Calibration".
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for HV Model LHD)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT