The yaw rate sensor has a built-in acceleration sensor.
The No. 2 skid control ECU (brake actuator assembly) receives signals from the yaw rate sensor via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C00631F | Yaw Rate Sensor Circuit Intermittent | When voltage at terminal +BS is 9.5 to 17.4 V, sensor invalid information received from yaw rate sensor is ON continuously for 10 seconds or more. | Yaw rate sensor | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| C05201F | Multi-axis Acceleration Sensor Module "A" Circuit Intermittent | When voltage at terminal +BS is 9.5 to 17.4 V, sensor invalid information received from acceleration sensor is ON continuously for 10 seconds or more. | Acceleration sensor (yaw rate sensor) | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
After replacing or reinstalling the yaw rate sensor, perform "Calibration".
Clear the DTCs.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| DTCs C00631F and C05201F are not output. | A |
| DTCs C00631F and/or C05201F are output. | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B