Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0421002 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  C006328  Yaw Rate Sensor Signal Bias Level Out of Range / Zero Adjustment Failure  C006396  Yaw Rate Sensor Component Internal Failure  


DESCRIPTION

These DTCs are stored when the No. 2 skid control ECU (brake actuator assembly) receives an internal malfunction signal from the yaw rate sensor.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C006328 Yaw Rate Sensor Signal Bias Level Out of Range / Zero Adjustment Failure With the vehicle stationary, the yaw rate sensor output value is not 0°/s. Yaw rate sensor Output ECU: No. 2 skid control ECU (brake actuator assembly)
C006396 Yaw Rate Sensor Component Internal Failure With the +BS terminal voltage between 9.5 and 17.4 V, a data malfunction signal is received from a yaw rate sensor. Yaw rate sensor Output ECU: No. 2 skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing or reinstalling the yaw rate sensor, perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>UTILITY


PROCEDURE

1.REPLACE YAW RATE SENSOR

NEXT

END