Brake pressure sensor "G": Wheel cylinder pressure sensor 2
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C063516 | Brake Pressure Sensor "G" Circuit Voltage Below Threshold | Wheel cylinder pressure sensor 2 value is below -0.744 MPa (-7.6 kgf/cm2, -107 psi) for 5 seconds or more. | No. 2 skid control ECU (brake actuator assembly) | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| C06351F | Brake Pressure Sensor "G" Circuit Intermittent | Fluctuation of the sensor signal exceeds the threshold (15 MPa (153.0 kgf/cm2, 2175 psi) or more from the previous value) for 0.1 seconds or more. | No. 2 skid control ECU (brake actuator assembly) | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| C063529 | Brake Pressure Sensor "G" Signal Invalid | Data from the sensor is invalid for 0.2 seconds or more. | No. 2 skid control ECU (brake actuator assembly) | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| C063531 | Brake Pressure Sensor "G" No Signal | Communication with the sensor is invalid for 0.1 seconds or more. | No. 2 skid control ECU (brake actuator assembly) | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| C063596 | Brake Pressure Sensor "G" Component Internal Failure | A malfunction is detected by self-diagnosis function of the sensor. | No. 2 skid control ECU (brake actuator assembly) | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| C110B16 | Brake Pressure Sensor "G" Supply Voltage Circuit Voltage Below Threshold | The supplied voltage to the sensor is less than a certain value for 1 second or more. | No. 2 skid control ECU (brake actuator assembly) | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
| C110B17 | Brake Pressure Sensor "G" Supply Voltage Circuit Voltage Above Threshold | The supplied voltage to the sensor is a certain value or more for 1 second or more. | No. 2 skid control ECU (brake actuator assembly) | Output ECU: No. 2 skid control ECU (brake actuator assembly) |
After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for HV Model LHD)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT