Home › Drivetrain › GF2A (TRANSFER / 4WD / AWD) › DYNAMIC TORQUE CONTROL AWD SYSTEM
RM37A0E _52 Drivetrain _086861 GF2A TRANSFER / 4WD / AWD _0421155 DYNAMIC TORQUE CONTROL AWD SYSTEM D

GF2A TRANSFER / 4WD / AWD  DYNAMIC TORQUE CONTROL AWD SYSTEM  CALIBRATION  


NOTICE:
·

When the 4WD ECU assembly is replaced, before removing the 4WD ECU assembly, it is necessary to perform ECU Data Save to save the original 4WD ECU assembly information.

·

When the 4WD ECU assembly is replaced, it is necessary to perform ECU Data Write.

·

When the front 4WD linear solenoid (transfer assembly) or rear 4WD linear solenoid (rear differential carrier assembly) is replaced, it is necessary to perform the following in order: ECU Data Initialization and Disconnect System Function Check.

·

When the temperature sensor is replaced, it is necessary to perform ECU Data Initialization.


Parts Replacement Compensation Table
Replaced Part Necessary Procedure
4WD ECU assembly
1.

ECU Data Save

2.

ECU Data Write


Front 4WD linear solenoid (transfer assembly)
1.

ECU Data Initialization

2.

Disconnect System Function Check


Rear 4WD linear solenoid (rear differential carrier assembly)
1.

ECU Data Initialization

2.

Disconnect System Function Check


Temperature sensor ECU Data Initialization
Tire ECU Data Initialization
(When performing tire replacement after RoB code X2104 is output)


ECU DATA SAVE


a.

According to the display on the GTS, perform ECU Data Save.

Chassis > Four Wheel Drive > Utility
Tester Display
ECU Data Save
50005 448 4542


ECU DATA INITIALIZATION


a.

According to the display on the GTS, perform ECU Data Initialization.

Chassis > Four Wheel Drive > Utility
Tester Display
ECU Data Initialization
50005 448 4553


ECU DATA WRITE


a.

According to the display on the GTS, perform ECU Data Write.

Chassis > Four Wheel Drive > Utility
Tester Display
ECU Data Write
50005 448 4543


DISCONNECT SYSTEM FUNCTION CHECK


HINT:

Perform this work with 4 or more people as the tires need to be rotated by hand when working.


a.
C410356

According to the display on the GTS, perform Disconnect System Function Check.

Chassis > Four Wheel Drive > Utility
Tester Display
Disconnect System Function Check
50005 448 4552
CAUTION:

Do not hold the inside of the wheel when rotating the tire, as doing so could pinch your fingers.


NOTICE:
·

If disconnect switching fails, perform the same procedure. If it fails again, inspect the part.

When replacing the front 4WD linear solenoid (transfer assembly):

Click hereDrivetrain>GF2A (TRANSFER / 4WD / AWD)>TRANSFER ASSEMBLY>INSTALLATION

When replacing the rear 4WD linear solenoid (rear differential carrier assembly):

Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR DIFFERENTIAL CARRIER ASSEMBLY (for Dynamic Torque Control AWD)>INSTALLATION

·

If the wheels cannot be rotated at a suitable speed when performing this inspection, the inspection may not complete correctly and will need to be performed again.

·

If the rotational resistance is high when rotating the tire, continue to apply enough force to prevent the wheel from stopping.