Home › Drivetrain › GF2A (TRANSFER / 4WD / AWD) › DYNAMIC TORQUE CONTROL AWD SYSTEM
RM37A0E _52 Drivetrain _086861 GF2A TRANSFER / 4WD / AWD _0421155 DYNAMIC TORQUE CONTROL AWD SYSTEM J

GF2A TRANSFER / 4WD / AWD  DYNAMIC TORQUE CONTROL AWD SYSTEM  AWD Warning does not Come ON  


CAUTION / NOTICE / HINT

PROCEDURE

1.CHECK HARNESS AND CONNECTOR
a.

Check that there is no looseness at the locking and connecting parts of the 4WD ECU assembly connector.

OK:

No looseness at the locking and connecting parts



b.

Disconnect the M41 and M42 4WD ECU assembly connectors.


c.

Check the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion



d.

Connect the M41 and M42 4WD ECU assembly connectors.


Result:
Proceed to
OK
NG



OK

2.CHECK AWD WARNING MESSAGE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK AWD WARNING MESSAGE
a.

According to the display on the GTS, perform the Active Test and check the Data List "AWD Warning Light" turns ON/OFF.

Chassis > Four Wheel Drive > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
4WD Warning Light AWD warning (multi-information display) OFF / ON OFF: Warning off
ON: Warning on
-
Chassis > Four Wheel Drive > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
4WD Warning Light AWD warning (multi-information display) Warning ON/OFF Observe combination meter assembly
Chassis > Four Wheel Drive > Active Test
Active Test Display
4WD Warning Light
Data List Display
4WD Warning Light
50004 448 1 114

Result:
Result Proceed to
Data List display does not switch ON/OFF A
Data List display switches ON/OFF B



A

B

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)