Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER
RM37A0E _53 Suspension _086867 TIRE PRESSURE MONITORING _0421218 TIRE PRESSURE WARNING RECEIVER A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during tire pressure warning ECU and receiver removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Tire pressure warning ECU and receiver
·

Register transmitter ID

·

Initialize tire pressure warning system


·

DTC (Transmitter ID not Received) stored, tire pressure warning light blinks for 1 minute, then illuminates.

·

Tire pressure warning function


for Initialization:(Click here)
for Registration:(Click here)

Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Tire pressure warning ECU and receiver
·

Register transmitter ID

·

Initialize tire pressure warning system


·

DTC (Transmitter ID not Received) stored, tire pressure warning light blinks for 1 minute, then illuminates.

·

Tire pressure warning function


for Initialization:(Click here)
for Registration:(Click here)

NOTICE:

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST


PROCEDURE

Hide 64740C 1.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 897B0A 2.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

NOTICE:
·

Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.

·

If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.



a.
C415881

Remove the bolt.


b.

Disengage the 2 guides.


c.

Disconnect the connector to remove the tire pressure warning ECU and receiver.