Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RECEIVER › 2020.02–2020.11
RM37A0E _58 Vehicle Interior _086884 DOOR LOCK _0417746 DOOR CONTROL RECEIVER A

DOOR LOCK  DOOR CONTROL RECEIVER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during electrical key and tire pressure warning ECU and receiver removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link
·

Tire pressure warning ECU and receiver (Electrical key and tire pressure monitoring system receiver assembly)

·

Tire pressure warning valve and transmitter


·

Register transmitter ID

·

Initialize tire pressure warning system


·

DTC (Transmitter ID not Received) stored, tire pressure warning light blinks for 1 minute, then illuminates.

·

Tire pressure warning function


for Initialization:(Click here)
for Registration:(Click here)

NOTICE:

When replacing the electrical key and tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST


Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link
·

Tire pressure warning ECU and receiver (Electrical key and tire pressure monitoring system receiver assembly)

·

Tire pressure warning valve and transmitter


·

Register transmitter ID

·

Initialize tire pressure warning system


·

DTC (Transmitter ID not Received) stored, tire pressure warning light blinks for 1 minute, then illuminates.

·

Tire pressure warning function


for Initialization:(Click here)
for Registration:(Click here)

NOTICE:

When replacing the door control and tire pressure warning ECU and receiver or electrical key and tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST


PROCEDURE

Hide 1.REMOVE REAR NO. 2 SEAT ASSEMBLY

Hide 58387B 2.REMOVE REAR FLOOR FINISH PLATE

Hide 72138M 3.REMOVE REAR OUTER SEAT TRACK BRACKET COVER LH

Hide 67918A 4.REMOVE REAR DOOR SCUFF PLATE LH

Hide 62332C 5.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

a.

Disconnect the rear door opening trim weatherstrip LH.


Hide 64713F 6.REMOVE FRONT DECK SIDE TRIM COVER LH

Hide 64715E 7.REMOVE NO. 2 DECK SIDE TRIM COVER

Hide 64974 8.REMOVE DECK TRIM POCKET COVER

Hide 64725F 9.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

Hide 64740C 11.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 897B0A 12.REMOVE ELECTRICAL KEY AND TIRE PRESSURE WARNING ECU AND RECEIVER

NOTICE:
·

Do not drop, strike or otherwise subject the electrical key and tire pressure warning ECU and receiver to impact.

·

If the electrical key and tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.



a.
B569926

Remove the bolt.


b.

Disengage the 2 guides.


c.

Disconnect the connector to remove the electrical key and tire pressure warning ECU and receiver.