These DTCs are stored when a malfunction occurs in the radio receiver assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1550 | DAB Tuner Malfunction | When any of the following conditions is met:
·
DAB tuner decoder malfunction ·
DAB tuner audio output section malfunction ·
DAB tuner decoder RF/IF malfunction ·
DAB tuner control communication error ·
DAB tuner OFDM error ·
DAB tuner memory error |
Radio receiver assembly |
| B158D | Video Signal Stoppage | The internal video signal of the radio receiver assembly is interrupted | Radio receiver assembly |
| B15A0 | LAN Master Malfunction | When either of the following conditions is met:
·
Bus malfunction ·
EEPROM error |
Radio receiver assembly |
| B15B3 | Radio Tuner Malfunction | When any of the following conditions is met:
·
AM tuner PLL is unlocked ·
FM tuner PLL is unlocked ·
Tuner malfunction |
Radio receiver assembly |
| B15B7 | Bluetooth Module Malfunction | "Bluetooth" module malfunction | Radio receiver assembly |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG