The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during crankshaft position sensor removal/installation are shown below.
17150
1.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH (TWC: Front Catalyst)
19312
2.REMOVE CRANKSHAFT POSITION SENSOR PROTECTOR
Remove the nut and hose clamp from the crankshaft position sensor protector.
Remove the 3 bolts and crankshaft position sensor protector from the cylinder block sub-assembly and oil pan sub-assembly.
11401G
3.REMOVE CRANKSHAFT POSITION SENSOR
Disconnect the crankshaft position sensor connector.
Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.
If the crankshaft position sensor has been struck or dropped, replace it.
| *A | Type A |
| *B | Type B |
| *1 | O-ring |
Perform this procedure only when reusing the crankshaft position sensor.
Remove the O-ring from the crankshaft position sensor.
Make sure to only remove the O-ring with bare hands.
When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.
If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.