Home › General › MAINTENANCE › 2GR-FKS BATTERY › from 2020.11
RM37A0E _V1 General _086848 MAINTENANCE _0419974 2GR-FKS BATTERY A

MAINTENANCE  2GR-FKS BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Idle the engine for approximately 5 to 60 minutes or drive the vehicle until stop and start control is permitted Stop and Start System (Click here)
Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
Replacement of Battery
·

Integrated Current Value Initialization

·

Switch Battery Type


Stop and Start System (Click here)

NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.

·

When replacing the battery, use a new battery of the same dimensions and same capacity or more from the same class at a 20-hour rate.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

a.
A454725C02
0.031,0.292 0.344,0.531 0.313,0.24 12 true *A 0.031,2.625 0.344,2.865 0.313,0.24 12 true *B
*A w/ Stop and Start System
*B w/o Stop and Start System


Loosen the nut, and disconnect the cable from the negative (-) battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 2.REMOVE BATTERY

a.
A454727C01
0.656,0.281 0.969,0.438 0.313,0.156 10 false *a
*a Side View of Claws
V113146

Push Battery Terminal Cap Here
V113147

Push


Disengage the 2 claws as shown in the illustration and remove the battery terminal cap from the positive (+) battery terminal.


b.
A454728

Loosen the nut and disconnect the cable from the positive (+) battery terminal.


c.
A454729C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the bolt and No. 2 battery clamp from the battery clamp sub-assembly.


d.

Remove the battery from the vehicle.