Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM (for Gasoline Model) › from 2020.11
RM37A0E _51 Engine / Hybrid System _086858 CRUISE CONTROL _0418320 DYNAMIC RADAR CRUISE CONTROL SYSTEM(for Gasoline Model) C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM(for Gasoline Model)  U031857  Software Incompatibility with Brake System Control Module Invalid/Incompatible Software Component  


DESCRIPTION

If the vehicle information stored in the forward recognition camera does not match the vehicle information sent from the skid control ECU (brake actuator assembly), the forward recognition camera stores DTC U031857.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
U031857 Software Incompatibility with Brake System Control Module Invalid/Incompatible Software Component The vehicle information sent from the skid control ECU (brake actuator assembly) does not match that stored in the forward recognition camera.
·

Electronically controlled brake system

·

Forward recognition camera


Radar Cruise2

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the forward recognition camera, replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.

·

When the forward recognition camera is replaced with a new one or the windshield glass is replaced or removed/installed, make sure to read Before Starting Adjustment, then perform optical axis alignment for the forward recognition camera and clear the vehicle control history for each system.

HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.

One Time Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>TARGET ADJUSTMENT(ONE TIME RECOGNITION)

Sequential Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>TARGET ADJUSTMENT(SEQUENTIAL RECOGNITION)

Driving Adjustment: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>DRIVING ADJUSTMENT




PROCEDURE

1.CHECK FOR DTCs
a.

Check for electronically controlled brake system DTCs.

Chassis > Brake/EPB > Trouble Codes
50001 435

Result:
Result Proceed to
Electronically controlled brake system DTCs are not output A
Electronically controlled brake system DTCs are output B



A

REPLACE FORWARD RECOGNITION CAMERA

B