Home › Engine / Hybrid System › CRUISE CONTROL › LANE CONTROL SYSTEM › from 2020.11
RM37A0E _51 Engine / Hybrid System _086858 CRUISE CONTROL _0418322 LANE CONTROL SYSTEM T

CRUISE CONTROL  LANE CONTROL SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

If CAN communication system and lane control system DTCs are not output and any of the following problem symptoms exist, perform troubleshooting by checking the appropriate suspected areas in the order they are listed.

·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Lane Control System
Symptom Suspected Area Link
Lane control system cannot be enabled Steering pad switch circuit Click here
Adjust forward recognition camera
HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.


One Time Recognition: Click hereClick here
Sequential Recognition: Click hereClick here
Driving Adjustment: Click hereClick here
The LTA indicator does not illuminate when the LTA main switch is operated Indicator circuit Click here
Steering pad switch circuit Click here
Combination meter assembly Click here
The LTA indicator does not turn off even when the LTA main switch is operated Indicator circuit Click here
Steering pad switch circuit Click here
Combination meter assembly Click here
Increase in cases that driver can see lane markers but system cannot detect lane markers Check if operating conditions are met Click here
Adjust forward recognition camera
HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.


One Time Recognition: Click hereClick here
Sequential Recognition: Click hereClick here
Driving Adjustment: Click hereClick here
Lane control system is operating, but system operation is not displayed on multi-information display Data List/Active Test
(LDA Control)
Click here
Combination meter assembly Click here
Buzzer does not sound even when vehicle deviates from its lane Combination meter assembly Click here