Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2020.11
RM37A0E _58 Vehicle Interior _086893 PRE-COLLISION _0418188 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  U041881  Invalid Data Received from Brake System Control Module Invalid Serial Data Received  


DESCRIPTION

for HV Model

The No. 2 skid control ECU (brake actuator assembly) sends signals indicating the status of the electronically controlled brake system to the forward recognition camera via CAN communication.

If the forward recognition camera receives an electronically controlled brake system malfunction signal from the No. 2 skid control ECU (brake actuator assembly), it will store this DTC.


for Gasoline Model

The skid control ECU (brake actuator assembly) sends signals indicating the status of the electronically controlled brake system to the forward recognition camera via CAN communication.

If the forward recognition camera receives an electronically controlled brake system malfunction signal from the skid control ECU (brake actuator assembly), it will store this DTC.


DTC No. Detection Item DTC Detection Condition Trouble Area
U041881 Invalid Data Received from Brake System Control Module Invalid Serial Data Received
for HV Model

When the ignition switch is ON for 3 seconds or more, the forward recognition camera receives an electronically controlled brake system malfunction signal from the No. 2 skid control ECU (brake actuator assembly) for 1 second or more.


for Gasoline Model

When the ignition switch is ON for 3 seconds or more, the forward recognition camera receives an electronically controlled brake system malfunction signal from the skid control ECU (brake actuator assembly) for 1 second or more.


·

Electronically controlled brake system

·

Forward recognition camera



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.

·

When the forward recognition camera is replaced with a new one or the windshield glass is replaced or removed/installed, make sure to read Before Starting Adjustment, then perform optical axis alignment for the forward recognition camera and clear the vehicle control history for each system.

HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.

One Time Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>TARGET ADJUSTMENT(ONE TIME RECOGNITION)

Sequential Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>TARGET ADJUSTMENT(SEQUENTIAL RECOGNITION)

Driving Adjustment: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>DRIVING ADJUSTMENT




PROCEDURE

1.CONFIRM MODEL
a.

Choose the model to be inspected.


Result:
Result Proceed to
for HV Model A
for Gasoline Model B



A

2.CHECK FOR DTCs

B

3.CHECK FOR DTCs
2.CHECK FOR DTCs
a.

Using the GTS, check for electronically controlled brake system DTCs.

Chassis > Brake/EPB > Trouble Codes
50001 435
Chassis > Brake Booster > Trouble Codes
50001 466
HINT:

If DTC U041881 is output by the pre-collision system, perform troubleshooting for the electronically controlled brake system.



Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

REPLACE FORWARD RECOGNITION CAMERA

B

3.CHECK FOR DTCs
a.

Using the GTS, check for electronically controlled brake system DTCs.

Chassis > Brake/EPB > Trouble Codes
50001 435
HINT:

If DTC U041881 is output by the pre-collision system, perform troubleshooting for the electronically controlled brake system.



Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

REPLACE FORWARD RECOGNITION CAMERA

B