Home › Drivetrain › UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › SHIFT LEVER › from 2020.11
RM37A0E _52 Drivetrain _094409 UA80E AUTOMATIC TRANSMISSION / TRANSAXLE _0449683 SHIFT LEVER A

UA80E AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT LEVER  REMOVAL  


PROCEDURE

Hide 1.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
C332327

·

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 2.REMOVE SHIFT LOCK RELEASE BUTTON COVER

a.
C449147C01
1.135,1.594 1.135,1.302 1.135,1.302 1.354,1.146 true 1.052,1.594 1.26,1.823 0.208,0.229 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the shift lock release button cover from the shift position indicator.

NOTICE:

Be careful not to damage the shift lock release button cover and shift position indicator.



Hide 55446A 4.REMOVE NO. 1 SWITCH HOLE BASE

Hide 55606 5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 58817A 6.REMOVE FRONT NO. 2 CONSOLE BOX INSERT

Hide 33820B 7.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

NOTICE:

Before disconnecting the transmission control cable assembly, check that the shift lever is in N.


a.
C449148

Disconnect the transmission control cable assembly from the transmission floor shift assembly.


b.
C449149C01
2.031,1.281 2.219,1.49 0.188,0.208 10 true *a
*a Counterclockwise


Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, disconnect the transmission control cable assembly from the transmission floor shift assembly.


Hide 8.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

a.
C449150C01
1.615,3.094 1.792,3.271 0.177,0.177 10 true *a 1.927,0.833 2.104,1.01 0.177,0.177 10 true *b
*a Transmission Control Switch Connector
*b Shift Lock Control ECU Connector


Disconnect the transmission control switch connector.


b.

Disconnect the shift lock control ECU connector.


c.

Disengage the 2 clamps to disconnect the wire harness from the transmission floor shift assembly.


d.
C449151

Remove the 4 bolts and transmission floor shift assembly from the shift and select lever support.