The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during thermistor assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
| Replaced Part or Performed Procedures
|
Necessary Procedures
|
Effect/Inoperative Function When Necessary Procedures are not Performed
|
Link
|
|
|
| Front bumper assembly*
|
·
Measurement of ultrasonic sensor detection angle
·
Ultrasonic sensor detection angle registration
|
Parking Support Brake System
|
( )
|
| Front television camera view adjustment
|
Panoramic View Monitor System
|
( )
|
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
| Replaced Part or Performed Procedures
|
Necessary Procedures
|
Effect/Inoperative Function When Necessary Procedures are not Performed
|
Link
|
|
|
| Front bumper assembly*
|
·
Measurement of ultrasonic sensor detection angle
·
Ultrasonic sensor detection angle registration
|
Parking Support Brake System
|
( )
|
| Front television camera view adjustment
|
Panoramic View Monitor System
|
( )
|