Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for RHD vehicles.
Use the same procedure for the RH side and LH side.
The following procedure is for the RH side.
87501A
1.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY (w/ Seat Heater System)
73230
2.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
73240
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
71073S
4.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
Disconnect the rubber band of the separate type front seatback cover.
72494A
5.REMOVE FRONT SEAT VERTICAL ADJUSTER HANDLE (for Driver Side)
| *a | Protective Tape |
|
Remove in this Direction |
Operate the front seat vertical adjuster handle and using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the front seat vertical adjuster handle as shown in the illustration.
72551B
6.REMOVE RECLINING HINGE COVER
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw.
Disengage the guide to remove the reclining hinge cover.
72525A
7.REMOVE RECLINING ADJUSTER RELEASE HANDLE
Remove the reclining adjuster release handle.
71848A
8.REMOVE SEAT ADJUSTER COVER CAP (for Driver Side)
| *a | Protective Tape |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws as shown in the illustration.
Disengage the 2 guides to remove the seat adjuster cover cap as shown in the illustration.
71811D
9.REMOVE FRONT SEAT CUSHION SHIELD (for Driver Side)
Disengage the claw and 2 guides.
Disengage the 2 claws.
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and slightly pull the front seat cushion shield as shown in the illustration.
|
Remove in this Direction |
Disengage the guide to remove the front seat cushion shield as shown in the illustration.
71861
10.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Driver Side)
|
Remove in this Direction |
Disengage the 2 claws and 2 guides as shown in the illustration.
Disengage the 2 claws to remove the front seat inner cushion shield.
71811D
11.REMOVE FRONT SEAT CUSHION SHIELD (for Front Passenger Side)
Disengage the 2 claws and 2 guides.
Disengage the 3 claws.
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw and slightly pull the front seat cushion shield as shown in the illustration.
|
Remove in this Direction |
Disengage the guide to remove the front seat cushion shield as shown in the illustration.
71861
12.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Front Passenger Side)
|
Remove in this Direction |
Disengage the 2 claws and 2 guides as shown in the illustration.
Disengage the 3 claws to remove the front seat inner cushion shield.
13.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Disengage the 2 hooks.
w/ Seat Heater System:
Disconnect the connector.
Disengage the clamp.
Disengage the claw and 4 clamps to separate the front seat airbag assembly wire harness.
Disengage the 4 clamps first.
Remove the 4 bolts.
Disengage the 4 guides to remove the separate type front seatback assembly from the separate type front seat cushion assembly.
71930A
14.REMOVE FRONT SEAT HEADREST SUPPORT ASSEMBLY
Disengage the 3 hooks.
w/ Seat Heater System:
Disengage the clamp.
Open the 2 fasteners.
Disengage the 4 claws and remove the 2 front seat headrest support assemblies.
15.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
Remove the separate type front seatback cover with pad.
71073S
16.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
Using a screwdriver, disengage the 9 claws and remove the separate type front seatback cover from the separate type front seatback pad as shown in the illustration.
| *a | Screwdriver | - | - |
87510M
17.REMOVE FRONT SEATBACK HEATER ASSEMBLY (w/ Seat Heater System)
73910A
18.REMOVE FRONT SEAT AIRBAG ASSEMBLY
71053S
19.REMOVE FRONT SEATBACK SPRING SUB-ASSEMBLY
Disengage the 2 claws to separate the 2 front seatback edge protectors from the front seatback frame sub-assembly.
|
Remove in this Direction |
Remove the front seatback spring sub-assembly from the front seatback frame sub-assembly as shown in the illustration.
71587
20.REMOVE FRONT SEATBACK EDGE PROTECTOR
Remove the 2 front seatback edge protectors from the front seatback spring sub-assembly.
71759C
21.REMOVE FRONT NO. 1 SEATBACK HOOK
Remove the 2 front No. 1 seatback hooks from the front seatback frame sub-assembly.
22.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
w/ Seat Heater System:
Disconnect the connector and disengage the clamp.
for Front Passenger Side:
|
Remove in this Direction |
Disengage the claw to separate the connector holder as shown in the illustration.
Disengage the 2 hooks.
Disengage the 10 hooks and remove the separate type front seat cushion cover with pad from the separate type front seat cushion spring assembly.
71071S
23.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Using a screwdriver, disengage the 14 claws and remove the separate type front seat cushion cover from the separate type front seat cushion pad as shown in the illustration.
| *a | Screwdriver | - | - |
87510K
24.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY (w/ Seat Heater System)
71875A
25.REMOVE RECLINING ADJUSTER INSIDE COVER RH (for Driver Side)
for RH Side:
Disengage the 4 claws to remove the reclining adjuster inside cover RH.
for LH Side:
Disengage the 4 claws to remove the reclining adjuster inside cover RH.
71876
26.REMOVE RECLINING ADJUSTER INSIDE COVER LH (for Front Passenger Side)
for RH Side:
Disengage the 4 claws to remove the reclining adjuster inside cover LH.
for LH Side:
Disengage the 4 claws to remove the reclining adjuster inside cover LH.
71873
27.REMOVE FRONT SEAT LOWER CUSHION SHIELD RH (for Driver Side)
for RH Side:
| *a | Hook |
| *b | Guide |
Disengage the hook.
Disengage the 2 claws and 2 guides to remove the front seat lower cushion shield RH.
for LH Side:
| *a | Hook |
| *b | Guide |
Disengage the hook.
Disengage the claw and guide to remove the front seat lower cushion shield RH.
82191
28.REMOVE FRONT SEAT WIRE (w/ Seat Heater System)
Disengage the claw and 3 clamps to remove the front seat wire.
71873V
29.REMOVE FRONT RH SEAT LOWER CUSHION SHIELD (for Driver Side)
|
Remove in this Direction |
Disengage the claw and guide to remove the front RH seat lower cushion shield as shown in the illustration.
Disengage the claw first.
7181A
30.REMOVE FRONT SEAT CUSHION WIRE HARNESS HOLDER
Remove the 2 screws.
Disengage the claw to remove the front seat cushion wire harness holder.
w/ Wiring Harness Connector:
Disengage the claw to remove the wiring harness connector from the front seat cushion wire harness holder.
71051A
31.REMOVE FRONT SEAT CUSHION SPRING SUB-ASSEMBLY
Disengage the 6 hooks to remove the front seat cushion spring sub-assembly from the front seat adjuster assembly.
72125U
32.REMOVE REAR UPPER SEAT TRACK COVER
Operate the seat track adjusting handle and move the front seat adjuster assembly to the rearmost position.
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped with protective tape, disengage the 4 claws to remove the rear upper seat track cover as shown in the illustration.
Use the same procedure for both sides.
72211
33.REMOVE SEAT TRACK ADJUSTING HANDLE
Operate the seat track adjusting handle and move the front seat adjuster assembly to the foremost position.
|
Remove in this Direction |
Disengage the 2 claws to remove the seat track adjusting handle from the front seat adjuster assembly as shown in the illustration.
72265
34.REMOVE SEAT TRACK UPPER RAIL COVER
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped with protective tape, disengage the 4 claws to remove the seat track upper rail cover as shown in the illustration.
Use the same procedure for both sides.
35.REMOVE VERTICAL ADJUSTER GEAR (for Driver Side)
Remove the vertical adjuster gear.
Remove the 3 nuts and vertical adjuster plate.
Remove the vertical adjuster spacer.
Remove the front vertical adjuster brake sub-assembly.
72498
36.REMOVE VERTICAL ADJUSTER BRACKET COVER (for Driver Side)
Disengage the claw to remove the vertical adjuster bracket cover from the front vertical adjuster brake sub-assembly.