The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during position control ECU assembly removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
2.REMOVE FRONT SEAT ASSEMBLY
89710
3.REMOVE POSITION CONTROL ECU ASSEMBLY
|
Screw |
|
Connector |
Disconnect the 3 connectors.
Remove the 3 screws and position control ECU assembly.