89342A
1.REMOVE REAR CENTER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
89342
2.REMOVE REAR CORNER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
89348S
3.REMOVE REAR CENTER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
89348R
4.REMOVE REAR CORNER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
5.REMOVE KICK DOOR CONTROL SENSOR WITH BRACKET (w/ Kick Sensor)
82183
6.REMOVE NO. 3 LUGGAGE ROOM WIRE
Disengage each clamp to remove the No. 3 luggage room wire.
| *A | w/ Kick Sensor | - | - |
81490C
7.REMOVE REAR FOG LIGHT ASSEMBLY LH
81480A
8.REMOVE REAR FOG LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
52151G
9.REMOVE REAR BUMPER EXTENSION
Disengage each clip.
| *A | w/o Kick Sensor | - | - |
Remove the 6 clips.
Disengage the 10 claws and 6 guides to remove the rear bumper extension.
52169C
10.REMOVE REAR BUMPER LOWER COVER
Remove the 2 screws and 4 clips.
|
Screw |
|
Clip |
Disengage the 14 claws and 2 guides to remove the rear bumper lower cover from the rear bumper cover.
52615
11.REMOVE REAR BUMPER ENERGY ABSORBER
Disengage the 7 claws to remove the rear bumper energy absorber.
52463
12.REMOVE REAR BUMPER PAD LH
Remove the rear bumper pad LH.
Use the same procedure for the RH side and LH side.
13.REMOVE REAR COMBINATION LIGHT SUB-ASSEMBLY LH
14.REMOVE REAR COMBINATION LIGHT SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
52563D
15.REMOVE REAR BUMPER UPPER RETAINER LH
Disengage the clamp.
Remove the screw and rear bumper upper retainer LH.
52562E
16.REMOVE REAR BUMPER UPPER RETAINER RH
Use the same procedure as for the LH side.
52156A
17.REMOVE REAR BUMPER SIDE SUPPORT LH
Perform this procedure only when replacement of the rear bumper side support LH is necessary.
Disengage the 3 clips as shown in the illustration.
Disengage the 2 claws to remove the rear bumper side support LH.
52155A
18.REMOVE REAR BUMPER SIDE SUPPORT RH
Use the same procedure as for the LH side.
52592
19.REMOVE REAR BUMPER SIDE SEAL LH
Perform this procedure only when replacement of the rear bumper side seal LH is necessary.
|
Screw |
|
Clip |
Remove the screw and clip.
|
Nut |
|
Clip |
Remove the nut, clip and rear bumper side seal LH.
52591
20.REMOVE REAR BUMPER SIDE SEAL RH
Use the same procedure as for the LH side.
52171C
21.REMOVE REAR BUMPER REINFORCEMENT
Perform this procedure only when replacement of the rear bumper reinforcement is necessary.
Remove the 6 nuts and rear bumper reinforcement.