TORQUE SENSOR ZERO POINT CALIBRATION (USING GTS)
Perform torque sensor zero point calibration if any of the following conditions occur:
The rack and pinion power steering gear assembly has been replaced.
There is a difference in steering effort between turning left and right.
Perform inspection before calibration.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Calibrate the rack and pinion power steering gear assembly. Enter the following menus: Chassis / EMPS / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| IG Power Supply | IG power source voltage | Min.: 0.0000 V
Max.: 20.1531 V |
8 to 16 V (w/o Stop and Start System)
10.5 to 16 V (w/ Stop and Start System) |
Ignition switch ON |
| Tester Display |
|---|
| IG Power Supply |
8 to 16 V*1
10.5 to 16 V*2
*1: w/o Stop and Start System
*2: w/ Stop and Start System
If the IG power supply voltage is 8 V or less*1 or 10.5 V or less*2, calibration cannot be performed. In this case, charge or replace the auxiliary battery, and then perform calibration.
*1: w/o Stop and Start System
*2: w/ Stop and Start System
Perform torque sensor zero point calibration.
If DTC C1516 (Torque Sensor Zero Point Adjustment Incomplete) is stored, the torque sensor zero point cannot be calibrated. Clear the DTCs before starting calibration.
Align the front wheels straight ahead and center the steering wheel.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / EMPS / Utility / Torque Sensor Adjustment.
| Tester Display |
|---|
| Torque Sensor Adjustment |
Do not turn the steering wheel sharply.
During the torque sensor zero point calibration the steering wheel will shudder. Do not touch the steering wheel until at least 3 seconds have elapsed after the shuddering has stopped.
ASSIST MAP WRITING (USING GTS)
Perform assist map writing if the following condition occurs:
The rack and pinion power steering gear assembly has been replaced.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / EMPS / Utility / Signal Check.
| Tester Display |
|---|
| Signal Check |
Follow the instructions on the GTS to perform Signal Check.
With DTC C1581 output, performing Signal Check will cause the rack and pinion power steering gear assembly to enter Signal Check and the assist map will be written automatically.
Wait for at least 5 seconds.
Check for DTCs.
After writing the assist map, if DTC C1581 is output, perform the troubleshooting procedure for DTC C1581.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>C1581