This DTC is stored when an open circuit or short occurs in the communication line between the rear center ultrasonic sensor LH and the rear center ultrasonic sensor RH, or when a malfunction occurs in the rear corner rear center ultrasonic sensor LH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE787 | Ultrasonic Sensor (Rear Left Center) Missing Message | Rear center ultrasonic sensor LH lost communication | ·
Rear center ultrasonic sensor LH ·
Harness or connector ·
Clearance warning ECU assembly |
Perform registration after replacing or removing and installing the ultrasonic sensor or clearance warning ECU assembly.
If a DTC is detected again after the repair, turn the ignition switch to ON and turn the TOYOTA parking assist-sensor system on, and then clear the DTC.
If C1AE896 is output at the same time, check C1AE896 first.
Register the TOYOTA parking assist-sensor system.
| Proceed to |
|---|
| NEXT |
NEXT
According to the display on the GTS, check for DTCs.
According to the display on the GTS, clear the DTCs.
Recheck for DTCs.
| Symptoms | DTC Detection | |||
|---|---|---|---|---|
| C1AE987 | C1AE887 | C1AE787 | C1AE687 | |
| Symptom 1 | Not output | Not output | Not output | Not output |
| Symptom 2 | Output | Output | Output | Output |
| Symptom 3 | Not output | Output | Output | Output |
| Symptom 4 | Not output | Not output | Output | Output |
| Symptom 5 | Not output | Not output | Not output | Output |
| Result | Proceed to |
|---|---|
| Listed under symptom 1 in combination table | A |
| Listed under symptom 2 in combination table | B |
| Listed under symptom 3 in combination table | C |
| Listed under symptom 4 in combination table | D |
| Listed under symptom 5 in combination table | E |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
D
E
Disconnect the V3 rear center ultrasonic sensor RH connector.
Disconnect the V2 rear center ultrasonic sensor LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| V3-1 (BO) - V2-4 (BI) | Always | Below 1 Ω |
| V3-2 (SO) - V2-5 (SI) | Always | Below 1 Ω |
| V3-3 (EO) - V2-6 (EI) | Always | Below 1 Ω |
| V3-1 (BO) or V2-4 (BI) - Body ground | Always | 10 kΩ or higher |
| V3-2 (SO) or V2-5 (SI) - Body ground | Always | 10 kΩ or higher |
| V3-3 (EO) or V2-6 (EI) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear center ultrasonic sensor LH.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>REMOVAL
Inspect the rear center ultrasonic sensor LH.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the rear center ultrasonic sensor LH with a known good one.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>REMOVAL
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
| Proceed to |
|---|
| NEXT |
NEXT
According to the display on the GTS, check for DTCs.
According to the display on the GTS, clear the DTCs.
Recheck for DTCs.
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| "C1AE787" is output | B |
A
B
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>CLEARANCE WARNING ECU (for RHD)>REMOVAL