The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission revolution sensor (NT) and transmission revolution sensor (NC) removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
35410
1.REMOVE TRANSMISSION VALVE BODY ASSEMBLY
89413N
2.REMOVE TRANSMISSION REVOLUTION SENSOR (NT)
Remove the bolt and transmission revolution sensor (NT) from the automatic transaxle case sub-assembly.
89413S
3.REMOVE TRANSMISSION REVOLUTION SENSOR (NC)
Remove the bolt and transmission revolution sensor (NC) from the counter drive gear sub-assembly.