Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Power Seat) › from 2020.11
RM37A0E _58 Vehicle Interior _086895 SEAT BELT _0417480 FRONT SEAT INNER BELT ASSEMBLY(for Power Seat) A

SEAT BELT  FRONT SEAT INNER BELT ASSEMBLY(for Power Seat)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat inner belt assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)

Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Idle the engine for approximately 5 to 60 minutes or drive the vehicle until stop and start control is permitted Stop and Start System (Click here)
Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)

CAUTION:
·
B401522

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION



NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.



HINT:
·

Use the same procedure for RHD and LHD.

·

The following procedure is for LHD.



PROCEDURE

Hide 73240 2.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)

a.

Disengage each clamp under the front seat assembly.


b.
B560978

Disengage the clamp.


c.

Remove the nut and front seat inner belt assembly.


d.
B560979C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the front seat belt anchor plate as shown in the illustration.


Hide 73230 3.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)

a.

Disengage the clamp under the front seat assembly.


b.
B560980

Disengage the clamp.


c.

Remove the nut and front seat inner belt assembly.


d.
B560981C02
0,0 0,0 false
V113147

Remove in this Direction


Remove the front seat belt anchor plate as shown in the illustration.