Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SYSTEM › from 2020.11
RM37A0E _59 Vehicle Exterior _086899 WINDOW / GLASS _0416697 WINDOW DEFOGGER SYSTEM J

WINDOW / GLASS  WINDOW DEFOGGER SYSTEM  Rear Window Defogger System does not Operate  


DESCRIPTION

When the rear window defogger switch on the air conditioning control assembly is pressed, the operation signal is transmitted to the air conditioning amplifier assembly via LIN communication. When the air conditioning amplifier assembly receives the signal, it turns on the DEF relay to operate the window defogger system.

WIRING DIAGRAM

B567680E03
0.135,1.021 1.688,1.531 1.552,0.51 10 false from Auxiliary Battery 2.167,1.219 2.531,1.469 0.365,0.25 10 false DEF 1.813,2.208 2.865,2.438 1.052,0.229 10 false ECU-IG1 NO. 3 0.146,2.021 1.594,2.344 1.448,0.323 10 false from IG1-NO. 1 Relay 3.167,2.396 4.083,2.594 0.917,0.198 10 false DEF 4.74,1.198 6.479,1.823 1.74,0.625 10 false Rear Window Defogger Wire (Back Door Glass) 5.094,1.958 6.01,2.156 0.917,0.198 10 false RDFG 5.073,4.094 5.563,4.323 0.49,0.229 10 false LIN1 5.656,4.094 6.146,4.354 0.49,0.26 10 false GND 4.813,4.792 6.365,5.219 1.552,0.427 10 false Air Conditioning Amplifier Assembly 2.24,4.656 4.344,5.24 2.104,0.583 10 false Rear Window Defogger Switch (Air Conditioning Control Assembly) 2.24,4.5 2.594,4.708 0.354,0.208 10 false H27 4.719,2.042 5.073,2.25 0.354,0.208 10 false H63 0.677,5.146 3.01,5.469 2.333,0.323 10 false : LIN Communication Line 3.969,3.938 4.51,4.188 0.542,0.25 10 false 3*1, 8*2 3.604,4.104 3.958,4.313 0.354,0.208 10 false LIN1 4.781,3.875 5.135,4.083 0.354,0.208 10 false 7 6.063,3.885 6.417,4.094 0.354,0.208 10 false 17 5.719,2.073 6.073,2.281 0.354,0.208 10 false IC 4.75,1.854 5.104,2.063 0.354,0.208 10 false 18 3.792,1.938 4.146,2.146 0.354,0.208 10 false 1 2.729,1.948 3.083,2.156 0.354,0.208 10 false 2 2.74,0.958 3.094,1.167 0.354,0.208 10 false 5 2.74,0.563 3.094,0.771 0.354,0.208 10 false 4 3.792,0.76 4.146,0.969 0.354,0.208 10 false 3 4.75,0.656 5.104,0.865 0.354,0.208 10 false 1 4.677,0.865 5.031,1.073 0.354,0.208 10 false W2 6.25,0.667 6.604,0.875 0.354,0.208 10 false 1 6.198,0.865 6.552,1.063 0.354,0.198 10 false W3 4.708,4.073 5.063,4.281 0.354,0.208 10 false H62 6.021,4.083 6.375,4.292 0.354,0.208 10 false H62 0.365,3.198 1.927,3.458 1.563,0.26 10 false *1: for 12.3 Inch Display 0.375,3.563 1.938,3.823 1.563,0.26 10 false *2: for 8 Inch Display

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following procedure.

·

If the auxiliary battery voltage becomes low, auxiliary battery load control will operate in order to ensure sufficient power is supplied to the power steering system. In this case, the window defogger system may not operate.



PROCEDURE

1.CHECK AIR CONDITIONING SYSTEM
a.

Check the air conditioning system.

HINT:

Both the window defogger system operation signal and air conditioning system operation signal are transmitted to the air conditioning amplifier assembly via the same communication line.


OK:

The air conditioning system operates normally.



Result:
Proceed to
OK
NG



OK

2.PERFORM ACTIVE TEST USING GTS

NG

2.PERFORM ACTIVE TEST USING GTS
a.

Perform the Active Test according to the display on the GTS.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Defogger Relay (Rear) Rear window defogger wire (Back door glass) OFF or ON -
Body Electrical > Air Conditioner > Active Test
Tester Display
Defogger Relay (Rear)
50004 121 22
OK:

The window defogger system operates normally.



Result:
Proceed to
OK
NG



OK

3.REPLACE REAR WINDOW DEFOGGER SWITCH (AIR CONDITIONING CONTROL ASSEMBLY)

NG

4.INSPECT DEF RELAY
3.REPLACE REAR WINDOW DEFOGGER SWITCH (AIR CONDITIONING CONTROL ASSEMBLY)
a.

Replace the rear window defogger switch (air conditioning control assembly) with a new or known good one.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PANEL>REMOVAL


b.

Check that the window defogger system operates normally.

Click hereVehicle Exterior>WINDOW / GLASS>WINDOW DEFOGGER SYSTEM>OPERATION CHECK

OK:

The window defogger system operates normally.



Result:
Proceed to
OK
NG



OK

END (REAR WINDOW DEFOGGER SWITCH (AIR CONDITIONING CONTROL ASSEMBLY) WAS DEFECTIVE)

NG

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

4.INSPECT DEF RELAY
a.
B319588

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 4 Auxiliary battery voltage applied to terminals 1 and 2 10 kΩ or higher
3 - 4 Auxiliary battery voltage not applied between terminals Below 1 Ω
3 - 5 Auxiliary battery voltage applied to terminals 1 and 2 Below 1 Ω
3 - 5 Auxiliary battery voltage not applied between terminals 10 kΩ or higher
4 - 5 Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

5.CHECK HARNESS AND CONNECTOR (DEF RELAY - IG1-NO. 1 RELAY AND AUXILIARY BATTERY)

NG

REPLACE DEF RELAY

5.CHECK HARNESS AND CONNECTOR (DEF RELAY - IG1-NO. 1 RELAY AND AUXILIARY BATTERY)
a.
B567673C03
0.125,0.083 0.417,0.354 0.292,0.271 10 false *a
*a DEF Relay Holder


Remove the DEF relay from the No. 1 engine room relay block and No. 1 junction block assembly.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
DEF relay holder terminal 2 - Body ground Ignition switch ON 11 to 14 V
DEF relay holder terminal 5 - Body ground Ignition switch off*1
Always*2
11 to 14 V


*1: for HV Model

*2: for Gasoline Model



Result:
Proceed to
OK
NG



OK

6.CHECK HARNESS AND CONNECTOR (DEF RELAY - AIR CONDITIONING AMPLIFIER ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.CHECK HARNESS AND CONNECTOR (DEF RELAY - AIR CONDITIONING AMPLIFIER ASSEMBLY)
a.
B567673C03
0.125,0.083 0.417,0.354 0.292,0.271 10 false *a
*a DEF Relay Holder


Remove the DEF relay from the No. 1 engine room relay block and No. 1 junction block assembly.


b.

Disconnect the H63 air conditioning amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
DEF relay holder terminal 1 - H63-18 (RDFG) Always Below 1 Ω
DEF relay holder terminal 1 or H63-18 (RDFG) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

7.CHECK HARNESS AND CONNECTOR (DEF RELAY - REAR WINDOW DEFOGGER WIRE (BACK DOOR GLASS))

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

7.CHECK HARNESS AND CONNECTOR (DEF RELAY - REAR WINDOW DEFOGGER WIRE (BACK DOOR GLASS))
a.
B567673C03
0.125,0.083 0.417,0.354 0.292,0.271 10 false *a
*a DEF Relay Holder


Remove the DEF relay from the No. 1 engine room relay block and No. 1 junction block assembly.


b.

Disconnect the W2 rear window defogger wire (back door glass) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
DEF relay holder terminal 3 - W2-1 Always Below 1 Ω
DEF relay holder terminal 3 or W2-1 - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

8.CHECK HARNESS AND CONNECTOR (REAR WINDOW DEFOGGER WIRE (BACK DOOR GLASS) - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

8.CHECK HARNESS AND CONNECTOR (REAR WINDOW DEFOGGER WIRE (BACK DOOR GLASS) - BODY GROUND)
a.

Disconnect the W3 rear window defogger wire (back door glass) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
W3-1 - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

9.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

9.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
a.
B567681C02
1.719,0.26 2.146,0.469 0.427,0.208 0.563,0.26 0.99,0.469 0.427,0.208 1.542,1.865 1.365,1.865 1.365,1.865 1.365,1.052 true 0.885,1.885 0.708,1.885 0.708,1.885 0.708,1.177 true 1.573,1.781 2.031,1.979 0.458,0.198 10 false GND 0.917,1.813 1.375,2.01 0.458,0.198 10 false RDFG 1.792,0.281 2.25,0.479 0.458,0.198 10 false H62 0.073,0.083 0.531,0.281 0.458,0.198 10 false *a 0.625,0.271 1.083,0.469 0.458,0.198 10 false H63
*a Component with harness connected
(Air Conditioning Amplifier Assembly)


Reconnect the H63 air conditioning amplifier assembly connector.


b.

Reinstall the DEF relay.


c.

Remove the air conditioning amplifier assembly with its connectors still connected.


d.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
H63-18 (RDFG) - H62-17 (GND) Ignition switch ON, rear window defogger switch on Below 1 V
H63-18 (RDFG) - H62-17 (GND) Ignition switch ON, rear window defogger switch off 11 to 14 V



Result:
Proceed to
OK
NG



OK

REPAIR OR REPLACE BACK DOOR GLASS

NG

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY