The swing grille actuator assembly receives signals from the ECM, hybrid vehicle control ECU and air conditioning amplifier assembly via CAN communication. Based on these signals, the swing grille actuator assembly operates the radiator shutter sub-assembly.
Before performing troubleshooting, change the grille shutter control mode to maintenance mode.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>GRILLE SHUTTER SYSTEM>INITIALIZATION
If the swing grille actuator assembly has been replaced with a new one, perform initialization and change the grille shutter control mode.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>GRILLE SHUTTER SYSTEM>INITIALIZATION
Check that the radiator shutter sub-assembly is free of foreign matter and ice.
The radiator shutter sub-assembly is free of foreign matter and ice.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Swing Grille Actuator Assembly) |
Disconnect the A52 swing grille actuator assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A52-1 (+B) - Body ground | Ignition switch off | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A52-3 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
According to the display on the GTS, perform the Active Test to open and close the grille shutter.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Shutter Closing Operation Lock Detection | Function to perform a closing operation until motor lock is detected and the motor stops | OFF/Close | - |
| Shutter Opening Operation Lock Detection | Function to perform an opening operation until motor lock is detected and the motor stops | OFF/Open | - |
| Tester Display |
|---|
| Shutter Closing Operation Lock Detection |
| Tester Display |
|---|
| Shutter Opening Operation Lock Detection |
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Shutter Operation Lock Detection Result for Active Test | Result of Active Test Shutter Closing Operation Lock Detection and Shutter Opening Operation Lock Detection | Normal, Open Error or Close Error | Normal: Normal lock detected
Open Error: Lock detected in abnormal position while performing Active Test Shutter Opening Operation Lock Detection Close Error: Lock detected in abnormal position while performing Active Test Shutter Closing Operation Lock Detection |
| Tester Display |
|---|
| Shutter Operation Lock Detection Result for Active Test |
"Normal" is displayed on the GTS.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Remove the radiator shutter sub-assembly.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>GRILLE SHUTTER>REMOVAL
Remove the swing grille actuator assembly.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>GRILLE SHUTTER>DISASSEMBLY
Manually open and close the radiator shutter sub-assembly and check that it moves smoothly.
The radiator shutter sub-assembly moves smoothly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG