The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during grille shutter removal/installation are shown below.
1.REMOVE FRONT BUMPER ASSEMBLY
16695A
2.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH
Disengage the claw to remove the front radiator side air guide plate LH.
16691A
3.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH
Disengage the 2 claws to remove the front radiator side air guide plate RH.
88790B
4.REMOVE THERMISTOR ASSEMBLY
53019F
5.REMOVE RADIATOR SHUTTER SUB-ASSEMBLY
Disconnect the connector.
Remove the 3 nuts and radiator shutter sub-assembly.