The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during grille shutter removal/installation are shown below.
1.REMOVE FRONT BUMPER ASSEMBLY
16695A
2.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH
Disengage the 2 claws to remove the front radiator side air guide plate LH.
16691A
3.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH
Disengage the 2 claws to remove the front radiator side air guide plate RH.
88790B
4.REMOVE THERMISTOR ASSEMBLY
53019F
5.REMOVE RADIATOR SHUTTER SUB-ASSEMBLY
Disconnect the connector.
Remove the 4 nuts and radiator shutter sub-assembly.