Home › ENGINE › 1TR-FE STARTING › STARTER

STARTER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.



2. REMOVE FRONT FENDER SEAL

  1. Remove the 5 clips and seal.



3. REMOVE STARTER ASSEMBLY


    G039040E01

  1. Disconnect the starter connector.

  1. Remove the nut and disconnect the starter wire.

  1. Remove the clutch release cylinder .

  1. Remove the 2 bolts and starter.