Home › ENGINE › 1KD-FTV COOLING › FAN

FAN > INSTALLATION

for Preparation Click here



1. INSTALL FAN


    A112113

  1. Install the fan to the coupling with the 4 nuts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



2. INSTALL FAN SHROUD

  1. Install the fan pulley to the water pump.

  1. Install the shroud together with the coupling fan between the radiator and engine component.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Install the fluid coupling fan to the fan pulley with the 4 nuts.
    Tighten the nuts as much as possible by hand.



    A110385

  1. Attach the shroud's claws to the radiator.

  1. Install the shroud with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Install the drive belt .

  1. Tighten the 4 nuts of the fluid coupling fan.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



    A110386

  1. Install the radiator reservoir with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the No. 1 and No. 2 water by-pass hoses to the tank upper and lower.



    A110387

  1. Install the oil reservoir with the 3 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



3. CONNECT RADIATOR HOSE INLET


4. ADD ENGINE COOLANT

  1. Add the engine coolant .



5. CHECK FOR ENGINE COOLANT LEAKS

  1. Check for the engine coolant leaks (Click here).



6. INSTALL NO. 1 ENGINE UNDER COVER

  1. Install the cover with the 4 bolts.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }