Throttle Body
Engine Control System
ON-VEHICLE INSPECTION
1. CHECK THROTTLE BODY
(a) Check the throttle control motor operating sound.
(1) Turn the ignition switch ON.
(2) When pressing the accelerator pedal, check the operating sound of the running motor. Make sure no friction noises emit from the motor.
If friction noise is heard, replace the throttle body.
-
(b) Check the throttle position sensor.
(1) Connect the intelligent tester to the DLC3.
(2) Turn the ignition switch ON.
(3) Under Current Data, check the throttle valve opening percentage (Throttle Pos) is within the standard.
Standard throttle valve opening percentage:
60% or more
NOTICE:
When checking the standard throttle valve opening percentage, the shift lever should be in the N position.
If the percentage is less than 60%, replace the throttle body.
-
(c) Inspect the air assist system.
(1) Start the engine and check the Check Engine (CHK ENG) warning light does not illuminate.
(2) Warm up the engine to the normal operating temperature.
(3) Turn the A/C compressor to ON then OFF and check the idle speed.
Standard idle speed (with the gear position in neutral):
650 to 750 rpm
NOTICE:
Perform this inspection without any electrical load on the vehicle.
-
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seatbelt pretensioner activation.
HINT:
Obtain the audio system PIN from the vehicle owner, if applicable. Otherwise the audio system will be inoperable when the battery cable is reconnected.
2. DRAIN ENGINE COOLANT (
Click Here
)
3. DISCONNECT NO. 2 VENTILATION HOSE (
Click Here
)
4. REMOVE AIR CLEANER ASSEMBLY (
Click Here
)
5. REMOVE THROTTLE BODY
(a) Disconnect the No. 5 water by-pass hose.
-
(b) Disconnect the No. 4 water by-pass hose.
-
(c) Disconnect the throttle motor connector.
-
(d) Remove the 4 bolts and throttle body.
-
(e) Remove the gasket from the supercharger and discard.
-
INSPECTION
1. INSPECT THROTTLE BODY
INSTALLATION
1. INSTALL THROTTLE BODY
(a) Install a new gasket to the supercharger.
-
(b) Install the throttle body with the 4 bolts.
Torque:
11 N*m
(112 kgf*cm,
9 ft.*lbf)
-
(c) Connect the throttle motor connector.
-
(d) Connect the No. 4 water by-pass hose.
-
(e) Connect the No. 5 water by-pass hose.
-
2. INSTALL AIR CLEANER ASSEMBLY (
Click Here
)
3. CONNECT NO. 2 VENTILATION HOSE (
Click Here
)
4. ADD ENGINE COOLANT (
Click Here
)
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. CHECK FOR ENGINE COOLANT LEAKS (
Click Here
)
7. PERFORM INITIALISATION
(a) Enter the audio system PIN, if applicable. Refer to Section 1-8 "Audio System" in the TRD Hilux Driver's Manual for programming information.
-
(b) Calibrate the multi-information display compass. Refer to Section 1-10 "Other Equipment" in the TRD Hilux Driver's Manual for calibrating information.
-
